DIGGA AUSTRALIA PTY LTD is selling this:

Digga TORQUE MEASURING SYSTEM

Make
Digga
Model
TORQUE MEASURING SYSTEM
Category
Machinery Attachments: Auger Drife
Year
2015
Location
Australia: Australia
4 Octal St, Yatala, QLD, 4207, Australia
Condition
New
Price
Price on Request

Description

  • Why use a Pressure Differential Gauge?
  • When screw anchoring, a torque reading is required to ensure the pile/pier has been screwed in at the correct specification. Project engineers will generallly demand that a specific torque amount is reached depending on what the piles or piers are being used for.
  • Traditionally, torque is calculated by a single sensor located at the hydraulic pump in the excavator. Unfortunately, this is not accurate as pressure is lost as oil travels up the boom through the drive unit and back again along the boom to the excavator. Pressure readings can be out by as much as 15-20% compared to actual working pressure.
  • Digital display of analogue signals Clear 4-digit 7-segment LED display Up to 3 analogue inputs ( 4.. 20mA or 0 .. 5 V) Accuracy ≤ ± 0.5% Differential measurement possible Analogue output ( 4.. 20mA or 0 .. 10 V) Up to 4 relay switching outputs RS232 interface Voltage supply - 12 .. 32V DC Option for PT100 sensor input or frequency input
  • Features & Benefits
  • Digga's Pressure Differential Gauge offers a more accurate way of measuring the true hydraulic pressure being applied through the hydraulic motor and gearbox of your drive unit. Hover your mouse over the features´ 'plus' symbol on the diagram below to reveal the respective benefits.
  • The system comprises of two sensors: The first sensor is located on the supply line at the entry to the drive unit. The second sensor is located on the return line where oil leaves the drive unit A micro processor calculates the 'actual usable' pressure using the two sensors - giving a reading which is up to 12-15% more accurate than traditional methods The reading is displayed in BAR or PSI depending on the option chosen at the time of purchase. This pressure read-out is compared to a supplied torque chart to obtain the equivalent torque reading in Nm
  • Pressure Differential Gauge Specifications
  • UNIT SPECIFICATIONS
  • Control Panel Housing: 96 mm x 48 mm x 109 mm
  • Control Panel Cut-out: 92 mm (+0.8) x 45 mm (+0.6)
  • Front Panel Thickness: 15 mm
  • Maximum Installation Depth: 121 mm
  • Contact DIGGA today and we will put you in touch with your closest supplier.
*
Ø
▼

Similar Machines

(Similar models of the same year with comparable operating hours.)